CHECKING AND STENCILING HIGH/LOW HAND THROTTLE POSITIONS

TM 9-2320-366-20-3

4-22. CHECKING AND STENCILING HIGH/LOW HAND THROTTLE POSITIONS

This task covers:

a. Checking High/Low Hand Throttle Positions

b. Stenciling High/Low Hand Throttle Positions

Equipment Conditions

Materials/Parts

Engine shut down (TM 9-2320-366-10-1).

Rubber Stamp Set, Fixed Type (Item 53, Appendix D)

Polyurethane Coating (Item 48, Appendix D)

Ink, Marking Stencil (Item 26, Appendix D)

Tools and Special Tools

STE/ICE-R (Item 41, Appendix C)

Inking Pad, Rubber Stamp (Item 27, Appendix D)

Gloves, Rubber (Item 13, Appendix C)

Respirator, Air Filter (Item 29, Appendix C)

References

TM 9-4910-571-12&P

TB 43-0209

a. Checking High/Low Hand Throttle Positions.

(1) Connect STE/ICE-R to DCA connector (1).

(2) Start engine (TM 9-2320-366-10-1).

(3) Position HAND THROTTLE lever (2) so that upper edge

of lever is even with line below L setting.

NOTE

Acceptable engine RPM with HAND

THROTTLE lever at L setting is 1250-1450

RPM.

(4) Perform STE/ICE-R test #10.