Stenciling High/Low Hand Throttle Positions.

TM 9-2320-366-20-3

4-22. CHECKING AND STENCILING HIGH/LOW HAND THROTTLE POSITIONS (CONT)

(5) Position HAND THROTTLE lever (2) so that upper edge

of lever is even with line below H setting.

NOTE

Acceptable engine RPM with HAND

THROTTLE lever at H setting is 2000-2200

RPM.

(6) Perform STE/ICE-R test #10.

(7) Perform subparagraph b. Stenciling High/Low Hand

Throttle Positions if engine RPM results from steps (4)

and (6) are not within acceptable limits.

b. Stenciling High/Low Hand Throttle Positions.

(1) Paint over old high and low HAND THROTTLE lever

position markings (TB 43-0209).

(2) Connect STE/ICE-R to DCA connector (1).

(3) Start engine (TM 9-2320-366-10-1).

(4) Perform STE/ICE-R test #10.