 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 11-6625-2609-34
it is returned to the using organization. These
3 - 7 . Modification Work Orders
procedures may also be used as a guide for testing
The performance standards listed in the tests
electronics equipment repaired by organizational
tion that all applicable modification work orders
personnel if the proper tools and test equipment
have been performed. A listing of current modi-
are available.
fication work orders will be found in DA Pam
310-7.
b. Comply with the instructions preceding each
chart before proceeding to the chart. Perform
3-8. Physical Tests and Inspections
each step in sequence, Do not vary the sequence.
a. Test Equipment and Materials. N o n e .
For each step, perform all the action required in
b. Test Connections and Conditions.
the Control settings columns; then perform each
(1) No connections necessary.
specific test procedure and verify it against its
(2) Remove cover from maintenance kit.
(3) Remove test panel from equipment case.
performance standard.
c. Procedure.
Control settings
Step
Performance standard
Test procedure
Test equipment
Equipment under test
No.
a. No damage evident or
Controls may be in any a. Inspect CY7345/ARC
1
None . . . . . . . . . . . . . . . . . .
parts missing. Exter-
(equipment case) and
position.
nal surfaces intended
test panel for dam-
to be painted will
age, missing parts,
not show bare metal.
and conditions of
Test panel lettering
paint.
will be legible.
NOTE
Touchup painting is rec-
ommended in lieu of re-
finishing whenever practi-
cal; screwheads, binding
posts, plugs, receptacles,
and other plated parts will
not be painted or polished
with abrasives.
b. No broken or burn
b. Inspect all cables, wir-
damage evident.
ing, resistors, and
capacitors for breaks
or burns.
c. Screws, bolts, and nuts
c. Inspect all controls and
will be tight. NO
assemblies for loose
missing items.
or missing screws,
bolts, and nuts.
d. No loose parts or dam-
d. Inspect all connectors,
age, No missing
plugs, jacks, recepta-
parts.
cles, lamps, and indi-
cators for looseness,
damage, or missing
parts.
e. Inspect maintenance kit
e. No missing items.
for missing items.
a. Controls will rotate
None . . . . . . . . . . . . . . . . . . Controls may be in any a. Rotate all controls
2
position.
throughout their lim-
freely without bind-
ing or excessive
its of travel.
looseness.
b. Stops
operate
b. Inspect dial stops for
will
properly without evi-
proper operation.
dence of damage.
c. Operate all switches
c. Switches will operate
properly.
d. All plugs will connect
d. Connect all plugs to
smoothly; no binding
their respective re-
or forcing required.
ceptacles.
3-9
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals