|
|
TM 9-2815-210-34-2-2
NOTE
A l l seven lower main bearing halves (1) have an aline-
m e n t tab (2) at center as shown.
M a i n bearing halves (1) and main bearing caps (3) are
c a l l e d by numbers one to seven counting from front to
r e a r o f c r a n k c a s e ( 4 ) . N u m b e r four main bearing half
a n d main bearing cap are called main thrust bearing half
a n d main thrust bearing cap.
L o w e r main thrust bearing half (1) has a flange (5) on
e a c h side. Main thrust bearing cap (3) is wider than
o t h e r main thrust bearing caps.
1.
S p r e a d a thin coat of Prussian blue on surface of lower main thrust bearing
h a l f (1) which rests against main thrust bearing cap (3).
H o l d main thrust bearing half (1) on main thrust bearing cap (3). Alinement
2.
t a b (2) must fit in notch (6) in main thrust bearing cap.
P u t a light coat of engine lubricating oil on edges (7) of main thrust bearing
3.
cap (3).
GO TO FRAME 65
4-88
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |