FRAME 65

TM 9-2815-210-34-2-2

FRAME 65

NOTE

M a i n bearing caps (1) with bearing halves (2) and main

b e a r i n g saddles (3) are called by numbers one to seven

c o u n t i n g from front to rear of crankcase (4).

N u m b e r four main bearing cap (1) is called main thrust

b e a r i n g cap. It is wider than other main bering caps.

N u m b e r four main bearing saddle (3) is called main thrust

bearing saddle. It is wider than other main bearing

saddles.

P u t main thrust bearing cap (1) with bearing half (2) on main thrust bearing

s a d d l e (3). Mounting holes in main thrust bearing cap must line up with

m o u n t i n g holes in main thrust bearing saddle.

C o a t two bolts (5) and washers (6) lightly with engine lubricating oil. Put

i n and hand tighten two bolts and washers.

U s i n g torque wrench, tighten two bolts (5) to 80 to 90 pound-feet.

U s i n g torque wrench, tighten two bolts (5) to 115 to 120 pound-feet.

GO TO FRAME 66

4-89