Section III. DISASSEMBLY OF ENGINE ASSEMBLY

T M 9-2815-210-34-2-1

DISASSEMBLY OF ENGINE ASSEMBLY

Section III.

NOTE

This procedure is the same for all engine models

except where noted.

E n g i n e transport stand, NSN 4910-00-338-6673

TOOLS:

E n g i n e maintenance stand, NSN 4910-00-529-8387

P u l l e r , NSN 5120-00-134-7463

P u l l e r kit, pn 8708724

P l u g , pn 10899178

W o o d block, 2x4x18 inches (2)

B r a s s rod

Lacquer, nitrocellulose, type I, TT-L-50

SUPPLIES :

Tool tags

Wire

S t e e l bar stock

B o l t (2)

Tags

PERSONNEL : TW O

Engine mounted on transport stand.

EQUIPMENT CONDITION:

3-31. MOUNTING ENGINE ON MAINTENANCE STAND.

Preliminary y Procedures.

(1) Remove engine from shipping container and place on transport stand.

R e f e r to para 2-3 through para 2-5.

(2) Remove generator and mounting bracket. Refer to para 3-4.

(3) Remove crankcase breather adapter. Refer to para 3-19.

(4) If engine is equipped with a turbocharger, remove turbocharger. Refer

(5) Remove oil pressure regulator valve. Refer to para 3-24.

( 6 ) Remove air compressor and mounting bracket. Refer to para 3-12 and

3-17.

(7) Remove fuel filter and mounting bracket. Refer to para 3-14.

(8) If engine is equipped with hydraulic pump, remove hydraulic pump.

R e f e r to para 3-13.

(9) Remove fuel injector pump and fuel injector lines. Refer to para 3-10

and 3-8.

(10) Remove oil filter and mounting bracket. Refer to para 3-11 and 3-15.

(11) Remove oil cooler and oil cooler water hose. Refer to para 3-15.

(12) Remove tappet chamber covers. Refer to para 3-16.

(13) Remove intake and exhaust manifolds. Refer to para 3-30.