Controller Installation.

TM 9-2320-366-20-3

b. Controller Installation.

NOTE

All four controllers are installed the same

way. Boom Up/Down controller shown.

(1) Install jam nut (1) on boom up/down controller (2).

(2) Install knob (3) on boom up/down controller (2).

(3) Tighten jam nut (1) against knob (3).

WARNING

Adhesives, solvents, and sealing com-

pounds can burn easily, can give off

harmful vapors, and are harmful to skin

and clothing. Keep away from open fire

and use in a well-ventilated area. If

adhesive, solvent, or sealing compound

gets on skin or clothing, wash

immediately with soap and water. Failure

to comply may result in injury to

personnel.

(4) Apply adhesive to seating surface (4).

(5) Connect connector (5) to boom up/down controller (2).

(6) Position boom up/down controller (2) in REMOTE

CONTROL UNIT (6).

(7) Apply adhesive to the first 2 to 5 threads of mounting

studs (7).

(8) Position four self-locking nuts (8) on boom up/down

controller (2).

(9) Tighten four self-locking nuts (8) to 14 lb-in. (2 Nm).

NOTE

Adhesive requires 24 hours to cure.

(10) Spread excess adhesive over heads of four self-locking

nuts (8).

Change 1

7-191