Installation. (cont) - TM-9-2320-366-20-30767

TM 9-2320-366-20-3

NOTE

Measure wires from body of start and

charging cable assembly.

(14) Cut wire (14) to 3 in. (7.6 cm) in length.

(15) Cut wire (15) to 4 in. (10.2 cm) in length.

(16) Remove 0.38 in. (1 cm) of insulation from two wires (14

and 15).

(17) Cut insulation sleeving (17) 1.5 in. (3.8 cm).

(18) Position insulation sleeving (17) on wire (15).

(19) Install conductor splice (18) on two wires (14 and 15).

(20) Install insulation sleeving (17) on conductor splice (18).

NOTE

Install electrical tape as required.

(21) Install convoluted tubing (13) on two wires (14 and 15).

(22) Deleted.

(23) Remove nut (19) from starting motor terminal (20).

(24) Position terminal lug TL53 (21), ground strap (22),

terminal lugs TL46 (23), and TL25 (24) on starting motor

terminal (20) with nut (19).

(25) Tighten nut (19) to 33-37 lb-ft (45-50 Nm).

WARNING

Adhesives, solvents, and sealing compounds

can burn easily, can give off harmful vapors,

and are harmful to skin and clothing. Keep

away from open fire and use in a well-

ventilated area. If adhesive, solvent, or

sealing compound gets on skin or clothing,

wash immediately with soap and water.

Failure to comply may result in injury to

personnel.

(26) Apply adhesive on terminal lug TL53 (21), ground strap

(22), terminal lugs TL46 (23), TL25 (24), nut (19), and

starting motor terminal (20).

Change 1

7-31