Installation. (cont) - TM-9-2320-366-20-30766

TM 9-2320-366-20-3

7-7. STARTING MOTOR REPLACEMENT (CONT)

WARNING

Starting motor weighs approximately 60

lbs (27 kgs). Attach a suitable lifting

device prior to installation. Failure to

comply may result in injury to personnel

or damage to equipment.

NOTE

Step (7) requires the aid of an assistant.

(7) Position starting motor (5) in flywheel housing (7) with

two screws (8).

(8) Position screw (9) in starting motor (5).

(9) Tighten two screws (8) and screw (9) to 47 lb-ft (64

Nm).

NOTE

Perform step (10) through (21) on vehicles

that have not had connector P81 removed.

(10) Cut connector P81 (10) from start and charging cable

assembly (11).

(11) Remove band marker (12) from start and charging cable

assembly (11).

NOTE

Remove electrical tape as required.

(12) Remove convoluted tubing (13) from two wires (14 and

15).

(13) Remove insulation sleeving (16) from two wires (14 and

15).

7-30

Change 1