Water Pump Installation. (cont) - TM-9-2320-366-20-30723

TM 9-2320-366-20-3

(9) Loosen two screws (12) in clamps (13) as far as possible

without disengaging screws from D-nuts (14).

(10) Unhook clamp tabs (15) from tab windows (16).

CAUTION

Clamp tongue must be started in clamp groove.

Failure to comply may result in damage to

equipment.

Position clamps with screw heads facing forward

so they do not interfere with alternator mount.

(11) Position coolant hose (17) on water pump (3).

(12) Position two clamps (13) on coolant hose (17).

(13) Engage as many clamp tabs (15) as possible in tab

windows (16) allowing little or no play between clamp

and coolant hose (17).

(14) Tighten two clamps (13) to 13-17 lb-in. (2 Nm).

NOTE

Minimum allowable gap on clamp is 0.2 in. (5

mm). If gap is less than 0.2 in. (5 mm),

remove and re-install clamp.

(15) Measure gap on two clamps (13).

(16) Install preformed packing (18) and 45-degree fitting (19)

in water pump (3).

(17) Connect heater supply tube (20) to 45-degree fitting (3).

Change 1

6-67