Water Pump Installation. (cont) - TM-9-2320-366-20-30722

TM 9-2320-366-20-3

6-12. WATER PUMP AND FITTINGS REPLACEMENT (CONT)

(4) Position drive belt/tension pulley (6) on engine (4) with

two washers (7) and screws (8).

(5) Install water pump drive belt (9) on water pump (3) and

drive belt/tension pulley (6).

NOTE

Use square hole in drive belt/tension pulley to

apply and maintain tension on drive belt while

adjusting belt tension.

(6) Adjust water pump drive belt (9) with drive belt/tension

pulley (6) as follows:

a. New belt (less than 30 minutes running time) 115-

125 lb (512-556 N).

b. Used belt 80-100 lb (356-444 N).

(7) Tighten two screws (8) to 35 lb-ft (47 Nm).

(8) Connect coolant tubes (10 and 11) to water pump (3).

6-66