HAND THROTTLE LEVER REPLACEMENT/ADJUSTMENT

TM 9-2320-366-20-3

4-17. HAND THROTTLE LEVER REPLACEMENT/ADJUSTMENT

This task covers:

a. Removal

c. Follow-On Maintenance

b. Installation/Adjustment

INITIAL SETUP

Equipment Conditions

Tools and Special Tools

Instrument panel assembly removed for access

Tool Kit, Genl Mech (Item 46, Appendix C)

Scale, Weighing (Item 30, Appendix C)

Materials/Parts

Washer, Spring (Item 294, Appendix G)

a. Removal.

Remove nut (1), washer (2), spring washer (3), HAND

THROTTLE lever (4), and friction disk (5) from dashboard

(6). Discard spring washer.

b. Installation/Adjustment.

WARNING

Tab of HAND THROTTLE lever must be

positioned above throttle pivot bar.

Failure to comply may result in injury to

personnel or damage to equipment.

(1) Position friction disk (5), HAND THROTTLE lever (4),

spring washer (3), washer (2), and nut (1) on dashboard

(6).

CAUTION

HAND THROTTLE lever nut must be

tightened so that 9-11 lbs (40-49 N) of force

is required to change position of HAND

THROTTLE lever. Failure to comply may

result in damage to equipment.

(2) Tighten nut (1) on HAND THROTTLE lever (4).

4-87