THROTTLE POSITION SENSOR (TPS) CABLE ASSEMBLY REPLACEMENT

TM 9-2320-366-20-3

4-16. THROTTLE POSITION SENSOR (TPS) CABLE ASSEMBLY REPLACEMENT

This task covers:

a. Removal

b. Installation

INITIAL SETUP

Equipment Conditions

Materials/Parts

Batteries disconnected (para 7-57).

Pin, Cotter (Item 224, Appendix G)

Cab raised (TM 9-2320-366-10-1).

Tools and Special Tools

Tool Kit, Genl Mech (Item 46, Appendix C)

a. Removal.

(1) Disconnect electrical connector (1) from TPS cable

assembly (2).

(2) Remove three nuts (3), washers (4), screws (5), and

TPS cable assembly (2) from bracket (6).

(3) Remove cotter pin (7) and washer (8) from stud (9).

Discard cotter pin.

(4) Remove TPS cable assembly (2) from stud (9).

(5) Release latch (10) on clamp (11).

(6) Remove TPS cable assembly (2) from clamp (11).

(7) Remove TPS cable assembly (2) from engine.