Assembly. - TM-9-2320-279-20-11050

TM 9-2320-279-20-1

Electrical System Maintenance Instructions (Cont)

7-92.1. NATO SLAVE RECEPTACLE AND BOX REMOVAL/REPAIR/INSTALLATION

(CONT).

Remove four screws (11), washers (12),

(5)

locknuts (13), and cap assembly (14)

from receptacle (7).

Remove receptacle (7), insulator (15),

(6)

and plastic insulator (15.1) from box (3).

c. Assembly.

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors,

and are harmful to skin and clothing. lb avoid injury or death, keep away from open fire

and use in well-ventilated area. If adhesive, solvent, or sealing compound gets on skin or

clothing, wash immediately with soap and water.

NOTE

When installing receptacle, make sure positive terminal (+) is on right side of box.

M983 Tractors have a slave cable retention device on the NATO slave cable

connector box. Other models do not.

Insulator located between receptacle and box may be either plastic or rubber

material. Rubber insulator does not need adhesive-sealant applied. Perform step (1)

for plastic insulator only.

Apply silicone adhesive-sealant to both sides

(1)

of plastic insulator (0.1).

(1.1) Install receptacle (1), plastic insulator (0.1),

and insulator (2) in box (3).

(2) Install cap assembly (4) in receptacle (1)

with four screws (5), washers (6), and

locknuts (7). Put cap on receptacle.