ENGINE OIL SAMPLING VALVE AND FITTINGS REMOVAL/INSTALLATION.

TM 9-2320-279-20-1

Engine Maintenance Instructions (Cont)

3-8. ENGINE OIL SAMPLING VALVE AND FITTINGS REMOVAL/INSTALLATION.

This task covers:

a. Engine Oil Sampling Valve and Fittings

c. Follow-on Maintenance

Removal

b. Engine Oil Sampling Valve and Fittings

Installation

INITIAL SETUP

Models

References

All

None

Test Equipment

Equipment Condition

None

TM or Para

Condition Description

TM 9-2320-279-10 Left side engine panel

Special Tools

removed.

None

Special Environmental Conditions

Supplies

None

Compound, sealing, pipe thread,

Item 18, Appendix C

General Safety Instructions

Personnel Required

None

MOS 63S, Heavy wheel vehicle mechanic

NOTE

There are two kinds of sampling valves.

Both are removed and installed the same

way.

a. Engine Oil Sampling Valves and Fittings

Removal. Remove valve (1) and elbow (2) from

oil sending unit (3).

WARNING

Adhesives, solvents, and sealing

compounds can burn easily, can give off

harmful vapors, and are harmful to skin

and clothing. To avoid injury or death,

keep away from open fire and use in

well-ventilated area. If adhesive, solvent,

or sealing compound gets on skin or

clothing, wash immediately with soap and

water.

b. Engine Oil Sampling Valve and Fittings

Installation. Apply pipe thread sealing

compound and install elbow (2) and valve (1) in

oil sending unit (3).

Follow-on Maintenance. Install left side engine panel (TM 9-2320-279-10).

END OF TASK

3-22

Change 3