|
|
TM 9-2320- 211-34-2-1
c.
Cleaning and Inspection.
WARNING
D r y cleaning sol vent is flammable. Do not use
n e a r an open flame. K e e p a fire extinguisher
n e a r b y when solvent is used. Use only in well-
ventilated places. Failure to do this may result
in injury to personnel and damage to equipment.
NOTE
Clean all parts before inspection, after repair,
and before assembly.
(1) Clean inner and outer surfaces of metallic parts and all areas subject
to oil or grease with dry cleaning solvent.
(2) Remove sludge and gum deposits with a stiff brush.
( 3 ) Steam cleaning may be used to remove accumulated grease and dirt
after dry cleaning solvent has been applied.
(4) Dry with clean rags.
(5) Rust must be taken off using a wire brush.
(6) Refer to para 1-3 for additional cleaning steps.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |