 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-211-34-2-1
FRAME
3
NOTE
Readings must be within limits given in table
8 - 7 . T h e letter L shows a loose fit and the
letter T shows a tight fit. If readings are not
w i t h i n given limits, t h r o w away part and get a
new one.
1.
Measure outside diameter of shaft (1).
2.
Measure fit of two bearings (2) on shaft (1).
Measure inside diameter of gear bore (3).
3.
4.
Measure fit of bearings (2) in gear bore (3).
END OF TASK
NOTE
CHECK ONLY THOSE PARTS WHICH ARE CALLED OUT.
PARTS WITHOUT CALLOUTS ARE SHOWN ONLY FOR
REFERENCE PURPOSES.
Input Shaft Low Speed Gear Assembly Wear Limits
Size and Fit
Index Number
of New Parts
I t e m / P o i n t of Measurement
Wear Limit
(inches)
(inches)
1 . 9 6 8 4 to 1.9689
1
Input shaft outer diameter
None
Fit of bearing on shaft
1 and 2
0.0008T
to
0.0003L
None
I n s i d e diameter of gear bore
3 . 9 3 6 1 to 3.9371
3
None
2 and 3
F i t of bearing in gear bore
0.0009T
to
0.0007L
None
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals