|
|
TM 9-2320-211-34-2-1
TRANSMISSION TRANSFER SYSTEM GROUP MAINTENANCE
Section I. SCOPE
8 - 1 . EQUIPMENT ITEMS COVERED. This chapter gives equipment maintenance
p r o c e d u r e s for the transmission transfer assembly and the transmission transfer
controls and linkages for which there are authorized corrective maintenance tasks
at the direct and general support maintenance levels.
8 - 2 . EQUIPMENT ITEMS NOT COVERED. All equipment items for which corrective
m a i n t e n a n c e is authorized at the direct and general support maintenance levels are
covered in this chapter.
S e c t i o n II. TRANSMISSION TRANSFER ASSEMBLY
TRANSMISSION TRANSFER REMOVAL AND REPLACEMENT.
Transfer case fixture,
TOOLS:
SUPPLIES:
None
PERSONNEL: One
EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.
a.
Preliminary
Procedures.
(1) Remove outer right forward-rear wheel. Refer to TM 9-2320-211-10.
(2) Remove inner right forward-rear wheel. Refer to TM 9-2320-211-10.
(3) Vent air system pressure. Refer to TM 9-2320-211-20.
(4) Remove transfer-to-forward-rear axle propeller shaft from transfer
case. Refer to TM 9-2320-211-20.
(5) Remove transfer-to-transmission propeller shaft from transfer case.
Refer to TM 9-2320-211-20.
(6) Remove transfer-to-front axle propeller shaft from transfer case.
R e f e r to TM 9-2320-211-20.
(7) For truck M543A2, remove power takeoff-to-power divider propeller
shaft from power takeoff unit on transfer case. Refer to TM 9-2320-211-20.
(8) Remove air hydraulic cylinder shield. Refer to TM 9-2320-211-20.
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |