FRONT WINCH AND ROLLER ASSEMBLY REMOVAL, REPLACEMENT, TEST, AND ADJUSTMENT.

TM 9-2320-211-20-3-2

18-7. FRONT WINCH AND ROLLER ASSEMBLY REMOVAL, REPLACEMENT,

TEST, AND ADJUSTMENT.

TOOLS: Hoisting equipment

Chain sling

Offset screwdriver

3/4-inch wrench (2)

18-inch hinged handle breaker bar

3/4-inch socket

SUPPLIES: None

PERSONNEL: Three

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

a. Removal.

FRAME 1

Put chain sling hoist onto front winch and roller assembly (1) as shown.

Using hoist, take slack out of chain and cable.

2. Take off propeller shaft front universal joint from yoke on winch driveshaft.

Refer to Part 1, para 10-11.

3. Using 3/4-inch wrenches, unscrew and take off three screws and lockwashers

(2) and three nuts (3) on both sides of front winch and roller assembly (1).

4. Using 3/4-inch wrench, unscrew and take off three screws, lockwashers,

and flat washers (4) on both sides of front winch and roller assembly (1).

5. Using hoist, lift front winch and roller assembly (1) to clear front bumper

(5). Take off front winch and roller assembly.

END OF TASK