Section III. WINDSHIELD

TM 9-2320-211-20-3-2

17-6. CAB WINDSHIELD ASSEMBLY REMOVAL AND REPLACEMENT.

NOTE

This task is the same for the right and left side

windshield assemblies. This task is shown for

the right side assembly.

TOOLS: 3/8-inch wrench

7/16-inch wrench

SUPPLIES: None

PERSONNEL: One

EQUIPMENT CONDITION: Truck parked, engine off, handbrake set.

a. Preliminary Procedure. Remove windshield wiper motor. Refer to para 19-8.

b. Removal.

FRAME 1

Lift up windshield lock handle (1).

Loosen two windshield adjusting arm thumbscrews (2).

Push forward on windshield lock handle (1) and open windshield assembly

(3). Tighten two screws (2).

4. Using 7/16-inch wrench, unscrew and take out two screws (4).

5. Using 3/8-inch wrench, unscrew and take out seven screws (5) while holding

windshield assembly (3). Take out windshield assembly.

END OF TASK