DRAG LINK RELAY LEVER REMOVAL AND REPLACEMENT .

TM 9-2320-211-20-3-2

14-7. DRAG LINK RELAY LEVER REMOVAL AND REPLACEMENT .

TOOLS: Pliers

7/16-inch wrench

1/2-inch drive ratchet

1/2-inch drive screwdriver bit

3/4-inch wrench (2)

Hammer

Brass drift

SUPPLIES : Dust shield (2)

PERSONNEL: One

EQUIPMENT CONDITION : Truck parked, engine off, handbrake set.

a. Removal.

FRAME 1

Using pliers, pull out cotter pin (1) from upper drag link (2) and lower drag

link (3). Throw away cotter pins.

2. Using pliers, unhook dust shield with felt pad (4) from upper and lower drag

links (2 and 3).

3. Using screwdriver bit, unscrew plug (5) at end of upper and lower drag links

(2 and 3) until one inch of thread shows.

4. Pull two drag links (2 and 3) away from relay lever (6).

5. Take off two dust shields with felt pads (4) and throw them away.

6. Using 7/16-inch wrench, unscrew and take out grease fitting (7).

7. Using 3/4-inch wrenches, unscrew nut (8) and take out bolt (9).

8. Using hammer and brass drift, drive out pin (10) at point (11) and take

off lever (6).

END OF TASK