Defuze Grenade, Hand

TM 9-1330-200-34/TM 1330-34/1

(5) Place fuze in packing support of shielded

(b) Solvent.

tray (fig. 5-7). Transfer to inspection operation or fuze

packing operation as required.

(6) Tools

and

equipment

include

the

(d) Rubber type, mounted (alt) stencil

following:

and stencil brush.

(a) Work table.

(e) Table, work.

(b) Vise, machinist 4 to 6 inches wide

(f) Can, safety, plunger-type.

jaw with wooden inserts.

(g) Gloves, disposable.

150 in. lb capacity.

d. Defuze Grenade, Hand (General Support

(d) Adapter, fuze wrench.

Maintenance Only).

For defuzing operations, see

(e) Support, packing (fig. 5-7).

paragraph 105c(6), TM 9-1300-206.

(f) Pitch-in barricade (fig. 5-8).

NOTE

e. Inspect Fuze, Grenade, Hand.

When positioning torque wrench in

(1) Receive grenade fuzes from preceding

vise, care will be taken to insure that

operation or from supply operator. Check lot number

only the gripping portion of the

and nomenclature to assure fuzes are those for intended

wrench handle is clamped in vise.

work.

The vise should be equipped with

(2) Inspect each fuze for defects specified in

wooden inserts to prevent damaging

paragraph 4-6d.

torque wrench.

(3) Place acceptable grenade fuzes

sectionalized tray and transfer to next operation.

(1) Place torque wrench in vise.

(4) Place defective fuzes in sectionalized

(2) Receive

grenade

from

preceding

reject tray for transfer to destruction area.

operation. Engage fuze body in fuze wrench adapter.

See figure 5-6.

(5) Tools

and

equipment

include

the

following:

WARNING

DO NOT USE IN EXCESS OF 100

(a) Work table.

INCH-POUNDS TO LOOSEN FUZE.

(b) Fuze tray, support packing (fig. 5-7).

GRENADES

WITH'

FUZES

REQUIRING IN EXCESS OF 100

INCH-POUNDS TO LOOSEN WILL BE

f. Assemble Fuze to Hand Grenade (General

REPACKED

FOR

SUBSEQUENT

Support Maintenance Only).

DISPOSAL OR REWORK BY DEPOT

OR LOADING PLANT PERSONNEL

(1) Receive grenade and fuze from preceding

AND FACILITIES.

operations.

(2) After assuring safe condition of safety pin,

remove from tray or packing support.

(3) Grasp grenade body, while observing

torque indicator, turn body in counterclockwise direction

(3) If M204A1

M204A2

Fuze,

until completely unscrewed from grenade fuze.

assemble fiberglass sleeve over fuze delay column

housing. Sleeve should slide over fuze housing and butt

(4) Remove grenade body from fuze.

against shoulder under threads. Adjust or replace if

necessary.

5-8