Section III. OPERATING UNDER USUAL CONDITIONS

TM55-1730-215-13 & P

Section III

OPERATING UNDER USUAL CONDITIONS

2-6. BEFORE OPERATING. When operating the maintenance platform under

usual conditions it is always necessary to open and close the vent

plug located on the pump assembly. To disregard this instruction will

result in early failure of pump gaskets and seals.

2-7. ASSEMBLY AND PREPARATION FOR USE.

a. Assembly. If the maintenance platform is received partially

disassembled, assemble as prescribed in paragraph 3-7.

b. Daily Checks. When assembly is completed before

equipment is put into use, complete the daily checks prescribed in

2-8. OPERATING PROCEDURE.

a. Operating the maintenance platform consists of raising the

platform by operating a hydraulic pump, and lowering the platform by

opening a release valve.

b. Before raising the platform to a required height, place the

platform in the desired location. Raise and lower the platform as

described in paragraph 2-2 and 2-3.

2-9. PREPARATION FOR MOVEMENT.

a. The platform assembly is equipped with casters to permit easy

movement. These casters are equipped with locks to prevent swiveling,

and two are provided with brakes to prevent movement when the platform

is in use. When in a work position, all casters must be locked.

b. The platform is equipped with elevation lock pins to prevent

accidental lowering. These pins must be installed before working from

the platform. See warning in paragraph 2-2.

c. The platform can be moved by towing with a vehicle. The platform

must be lowered before towing, and a speed of 5 MPH should never be

exceeded.

Section IV

OPERATING UNDER UNUSUAL CONDITIONS

2-10. The platform is made for Use on level, paved areas. Operating

the platform on rough, uneven ground is not recommended.

2-4