Section I. INTRODUCTION - TM-11-6625-1635-24P0005

TM 11-6625-1635-24P

SECTION I

INTRODUCTION

1. Scope

Definition

Code

PA-Item procured and stocked for anticipated or

This manual lists spares and repair parts; special

known usage.

tools; special test, measurement, and diagnostic

PD-Support item, excluding support equipment,

equipment (TMDE), and other special support

procured for initial issue or outfitting and

equipment required for performance of organiza-

stocked only for subsequent or additional

tional, direct support, and general support main-

initial issues or outfittings. Not subject to

tenance of the MK-1004/ARC.

automatic replenishment.

It authorizes the requisitioning and issue of spares

and repair parts as indicated by the source and

XD-A support item that is not stocked. When

required, item will be procured through

maintenance codes.

normal supply channels.

2. General

This Repair Parts and Special Tools List is divided

NOTE

into the following sections:

Cannibalization or salvage may be used

a. Section II. Repair Parts List. A list of spares

as a source of supply for any items

and repair parts authorized for use in the per-

source coded above except those coded

formance of maintenance. The list also includes

XA and aircraft support items as restrict-

parts which must be removed for replacement of

ed by AR 700-42.

the authorized parts. Parts lists are composed of

functional groups in numeric sequence, with the

parts in each group listed in figure and item

(2) Maintenance code. Maintenance codes

number sequence.

are assigned to indicate the levels of maintenance

b. Section III. Special Tools List. Not applic-

authorized to USE and REPAIR support items.

able.

The maintenance codes are entered in the third and

c. Section IV. National Stock Number and Part

fourth positions of the Uniform SMR Code format

Number Index. A list, in National item identifica-

as follows:

tion number (NIIN ) sequence, of all National stock

(a) The maintenance code entered in the

numbers (NSN) appearing in the listings, followed

third position will indicate the lowest maintenance

by a list, in alphameric sequence, of all part

level authorized to remove, replace, and use the

numbers appearing in the listings. National stock

support item. The maintenance code entered in the

numbers and part numbers are cross-referenced to

third position will indicate one of the following

each illustration figure and item number appear-

levels of maintenance:

ance.

Code

Application/Explanation

3. Explanation of Columns

O-Support item is removed, replaced, used at the

organizational level.

a. Illustration. This c o l u m n is d i v i d e d as

F-Support item is removed, replaced, used at the

follows:

direct support level.

(1) Figure number. Indicates the figure num-

(b) The maintenance code entered in the

ber of the illustration on which the item is shown.

fourth position indicates whether the item is to be

(2) Item number. The number used to

repaired and identifies the lowest maintenance level

identify item called out in the illustration.

with the capability to perform complete repair (i.e.,

b. Source, Maintenance, and Recoverability

all authorized maintenance functions). This posi-

(SMR) Codes.

tion will contain one of the following maintenance

(1) Source code. Source codes indicate the

codes:

manner of acquiring support items for mainten-

ance, repair, or overhaul of end items. Source

codes are entered in the first and second positions

of the Uniform SMR Code format as follows: