COMPONENT NAME

j. COMPONENT NAME - Enter nomenclature of item being measured (e.g.,

gun mach 7.62MM M60, M60C, M60D ).

k. REQUIRED COMPONENT DIMENSION - Enter dimensions of item being

measured as listed on component, or piece mark drawing.

l. ACTUAL GAGE DIMENSIONS - When dimensions are within the required

component dimension, enter the following statement: "Certified - All dimensions are

within drawing requirements".

Also indicate the activity that performed the

certification and state "Serviceable." When actual gage dimensions are out of required

component dimensions, indicate the actual dimensions and state "Out of required

component dimensions". Also indicate the activity performing the inspection and state

"Unserviceable".

m. REMARKS - Use as applicable.

DATE - Enter date gage certified.

GAGE CHECKER - Enter name of individual performing certification.

E-4. The activity performing certification completes the back of each DA Form 3023 (fig.

E-2), except as noted:

a. RECHECK GAGE AFTER EACH - Enter period of time, or specified number of

PIECES.

b. IDENTIFICATION NO - Enter complete identification or serial number.

Identification or serial number includes leading zeros, slashes, dashes, etc.

c. DATE ISSUED - Enter the date gage is issued (DD, MM, YY). NOTE: Initial

entry is provided by the activity performing the certification. Subsequent entries are

also made by the owner/user for each issue/use period of gage.

d. ISSUED TO - Enter name of recipient of gage (installation, individual, branch,

section, etc.).

NOTE: Initial entry is provided by the activity performing the

certification. Subsequent entries are made by the owner/user for each issue/use period

of gage.

e. GAGE SIZE LIMIT - Enter dimensional limit of gage when appropriate.

RECHECK SIZE - Enter dimensional recheck size of gage.

g. RECHECK DATE - Enter date of recheck (DD, MM, YY).

h. RECHECK BY - Enter gage inspector's name.

Change 1

E-2