Section I. INTRODUCTION - TB-43-0002-360004

TB 43-0002-36

Section I. INTRODUCTION

1. General.

b. Section III, Technical Inspections. This section Includes responsibilities

for performing inspections on repaired or evacuated items

a. This bulletin implements the policies established by AR 750-1. It pro-

c. Section IV Computation of Repair Cost Estimates. This section in-

vides one-time repair e expenditures limits, guidance for performing techni-

cal inspections, procedures for computing repair cost estimates, and

cludes instructions for preparing repair cost estimates for items listed

disposition instructions for for unserviceable excess equipment.

d. Section V, Disposition Instructions. This section includes disposition of

items where the repair is beyond the capability of support level mainte-

b. This bulletin applies to US Army organizations, installations, activities

nance.

and Reserve components worldwide that use and/or support FSC Group

66 materiel.

e. Section VI, Appendices. This section contains a listing of related publi-

cations referenced in this technical bulletin and expenditure limits for appli-

2. Format of Technical Bulletin. This bulletin is divided into the following:

cable stock classes.

a. Section II, One-Time Repair Expenditure Limits, This section Includes

procedures for determining expenditure limits for items listed under the

certain Federal Supply Classes.

Section II. ONE-TIME REPAIR EXPENDITURE LIMITS

3. Procedure.

(1) Identify the item by NSN, make, model and serial number and pro=

duction year. This data may be obtained from either the equipment

a. One-time expenditure limits are applicable each time an item IS repaired

data plate, the equipment log hook, or the property hook.

or overhauled. The one-time repair expenditure limit IS applied against the

(2) Obtain the standard price of the item from Department of the Army

standard price of the end item as listed a current Department of Army pub-

or Federal Supply Catalog (ML) or SB 700-20.

lications.

(3) Locate items in the appendix that contains the FSC Class to which

b. Due to the numerous National stock numbers, models and serial num-

item IS assigned.

her ranges applicable to this equipment, no production year has been in-

(4) Determine the percentage factor, columns 7 through 13, that is ap-

cluded in this bulletin for some equipment listed in Federal Supply Classes

plicable for the calendar year that repair or overhaul IS required.

6605, 6335, 6370, and 6675. The procedure for determining the repair ex-

penditure limits for these items is as follows:

(5) Multiply the end item standard price by the percentage factor (4)

above to determine the one-time allowable repair costs.

(1) Identify the item b NSN and production year. This data may be

obtained from the equipment data plate, equipment log book or prop-

4. Expenditure Limits.

erty hook.

a. The expenditure limit is 65 percent of acquisition cost of

(2) Obtain the standard price of the Item from Federal Supply Catalog.

assemblies, and recoverable repair parts applicable to the end item of

(3) Locate end item in appendices B, D, G, H and I of this bulletin.

equipment that have remaining repair eligibility cited in this bulletin.

(4) Determine the percentage factor, columns 7 through 13, that is ap-

plicable for the calendar year that repair or overhaul is required.

(5) Multiply the end item standard price by the percentage factor to

determine the one-time allowable repair cost.