DRIVE END BELL AND ROTOR ASSEMBLY. - TM-9-2920-225-340187

TM 9-2920-225-34

2-19. DRIVE END BELL AND ROTOR ASSEMBLY.

TOOLS: No special tools required

SUPPLIES: None

PERSONNEL: One

EQUIPMENT CONDITION : Generator removed from vehicle, pulley removed from

a. Preliminary Procedures.

(1) Clean outside of generator before disassembly. Refer to para 1-3.

(2) Remove fan and hub assembly. Refer to para 2-17.

(3) Remove slipring end housing. Refer to para 2-18.

b. Removal.

(1) Models 5504AA and 5504AB.

FRAME 1

Straighten tabs on six locking plates (1). Take out 12 screws (2) and

lockwashers (3) and six locking plates.

2. Take off coupling cover (4). Pull out driveshaft (5) and take two drive

blocks (6) from block holder (7).

3. Take retaining ring (8) from rotor shaft (9) and take off block holder (7).

GO TO FRAME 2

TA 103670

2-171