|
|
TM 9-2815-210-34-2-2
5 - 3 6 . TURBOCHARGER ASSEMBLY.
Engine LDT-465-1C.
a.
FRAME 1
CAUTION
Do not use open end wrench to put flame heater fuel
i n l e t adapter (1) or flame heater fuel return adapter
( 2 ) into nozzle and check valve assembly (3). Adap-
t e r s may be damaged. U s e only tubing wrench or box
wrench.
1.
Put fuel i n l e t adapter (1) into nozzle and check valve assembly (3).
Put fuel r e t u r n adapter (2) into nozzle and check valve assembly (3).
2.
NOTE
Make sure that locknut (4) is put onto nozzle and check
v a l v e assembly (3) before nozzle and check valve assem-
b l y is put into intake manifold elbow (5).
3.
H a n d tighten nozzle and check valve assembly (3) into intake manifold elbow
( 5 ) . Tighten locknut (4) against intake manifold elbow. Adapters (1 and 2)
s h o u l d face as shown.
P u t spark plug gasket (6) over end of spark plug (7) as shown. Put in
4.
s p a r k plug.
NOTE
Make sure that hose (8) is on end of intake elbow (5)
a n d that both hose clamps (9) are on hose.
GO TO FRAME 2
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |