|
|
TM
9-2815-210-34-2-2
b.
I n j e c t o r Tube Clamp.
FRAME 1
NOTE
Some
engines have six tube clamps and some have two
tube
clamps. T h i s task is shown for engines with six
tube
clamps. T w o screws (1) were put back after tubes
were
taken out.
1.
T a k e out two screws with flat washers (1). Put two brackets (2) in placse.
P u t in two screws with flat washers.
NOTE
Some engines do not have bracket (3).
2 . Put bracket (3) in place. Put in screw with lockwasher (4). Put clamp (5)
in place. P u t in two screws with flat washers and locknuts (6).
FOR ALL ENGINES EXCEPT LDS-465-2, GO TO FRAME 2.
FOR ENGINE LDS-465-2, GO TO FRAME 3
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |