|
|
TM
9-2815-210-34-2-2
FRAME 2
NOTE
If you are using push rods (1) that were taken out,
m a k e sure they go in push rod passage (2) they were
t a k e n from.
L o w e r one push rod (1) through each of 12 push rod passages (2) in cylinder
1.
h e a d s (3). Bottom end of push rod must fit through tappet bore (4) and
r e s t on tappet (5) inside crankcase (6) as shown.
GO TO FRAME 3
5-89
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |