FUEL INJECTOR TUBE ASSEMBLIES AND ATTACHING PARTS.

TM 9-2815-210-34-2-2

4-37. FUEL INJECTOR TUBE ASSEMBLIES AND ATTACHING PARTS.

Engine LDS-465-2.

(1) Cleaning.

FRAME 1

WARNING

Dry cleaning solvent is flammable. Do not use near an

o p e n flame. K e e p a fire extinguisher nearby when sol-

vent is used. Use only in well-ventilated places.

Failure to do this may result in injury to personnel

a n d damage to equipment.

CAUTION

Do not let dry cleaning solvent touch six rubber

boots (1). Boots will dry out and crack. If dry

c l e a n i n g solvent splashes on rubber boots, dry with

c l e a n cloth.

S l i d e six r u b b e r b o o t s ( 1 ) t o o n e e n d o f s i x f u e l i n j e c t o r t u b e s ( 2 ) . C l e a n

o u t s i d e of six fuel injector tubes with dry cleaning-solvent. Dry with clean

cloth .

S l i d e six rubber boots (1) to center of six fuel injector tubes (2). Clean

t h e ends of six fuel injector tubes which were covered by rubber boots in

step 1.

WARNING

Eye shields must be worn when using compressed air.

E y e injury can occur if eye shields are not used.

F l u s h inside of six fuel injector tubes (2) with dry cleaning solvent. Blow

d r y with compressed air. - Plug ends of six fuel injector tubes to keep out

dirt.

END OF TASK

TA 118495