AIR PRESSURIZATION TUBES AND FITTINGS (ENGINE LDS-465-2).

9-2815-210-34-2-2

4-27.

AIR PRESSURIZATION TUBES AND FITTINGS (ENGINE LDS-465-2).

a. C l e a n i n g .

FRAME

WARNING

Dry cleaning solvent is flammable. Do not use near an

open flame. Keep a fire extinguisher nearby when

solvent is used. Use only in well-ventilated places.

Failure to do this may result in injury to personnel

a n d damage to equipment.

E y e shields must be worn when using compressed air.

E y e injury can occur if eye shields are not used.

CAUTION

A i r pressurization tubes (1, 2 and 3) are copper tubes

c o v e r e d with a nonmetallic sheath. Generator air inlet

t u b e assembly (4) is made of rubber. Do not clean

r u b b e r generator air inlet tube assembly with dry

c l e a n i n g solvent or it will dry out and crack.

C l e a n inside of air pressurization tubes (1, 2 and 3) with brass wire probes.

F l u s h inside of air pressurization tubes (1, 2 and 3) with dry cleaning solvent.

B l o w dry with compressed air.

C l e a n rubber generator air inlet tube assembly (4) with soapy water. Blow

d r y inside of tube with compressed air.

GO TO FRAME 2