FRAME 5 - TM-9-2815-210-34-2-20284

9-2815-210-34-2-2

FRAME 5

NOTE

Readings must be within limits given in table 4-57.

The letter L shows a loose fit. I f readings are not

within given limits, throw away part and get a new

one.

R e a r end of rocker arm shaft (1) has a locating dowel

pin (2).

R o c k e r arm bearing surfaces of rocker arm shaft (1) are

s u r f a c e areas near the first, third, fourth, fifth, sixth,

a n d eighth oil holes in rocker arm shaft, counting from

f r o n t t o r e a r . B e a r i n g surfaces will look shiny on used

r o c k e r arm shafts.

M e a s u r e inside diameter of six rocker arm bearings (3). Note each measurement

and which rocker arm it was taken on.

M e a s u r e outside diameter of six rocker a r m bearing surfaces of rocker arm

s h a f t ( 1 ) . Note each measurement and w h i c h rocker arm bearing surface it

w a s taken on.

M e a s u r e fit of each rocker arm bearing ( 3 ) on its bearing surface of rocker

a r m shaft (1).

M e a s u r e length A of six valve adjusting screws (4).

GO TO FRAME 6

4-264