Harness Removal.

TM 9-2320-366-20-3

7-32. REMOTE CONTROL UNIT REPAIR (CONT)

WARNING

Adhesives, solvents, and sealing compounds can burn easily, can give off harmful vapors, and

are harmful to skin and clothing. Keep away from open fire and use in a well-ventilated area.

If adhesive, solvent, or sealing compound gets on skin or clothing, wash immediately with soap

and water. Failure to comply may result in injury to personnel.

(7) Apply adhesive to the first 2 to 5 threads of mounting

studs (11).

(8) Position four self-locking nuts (12) on boom up/down

controller (9).

(9) Tighten four self-locking nuts (12) to 14 lb-in. (2 Nm).

NOTE

Adhesive requires 24 hours to cure.

(10) Spread excess adhesive over heads of four self-locking

nuts (12).

e. Harness Removal.

NOTE

All four controllers are removed for harness

removal.

All four controllers are removed the same way.

Boom Up/Down controller shown.

(1) Remove four self-locking nuts (1) from boom up/down

controller (2). Discard self-locking nuts.

(2) Remove boom up/down controller (2) from REMOTE

CONTROL UNIT (3) until connector (4) is accessible.

(3) Disconnect connector (4) from boom up/down controller

(2).

(4) Remove adhesive from seating surface (5).

7-194

Change 1