 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-3
6-13. DRIVE BELT AND TENSION PULLEY REPLACEMENT (CONT)
b. Installation.
(1) Install drive belt (1) on pulley damper (2) and water
pump pulley (3).
(2) Position tension pulley (4) on engine (5) with two
washers (6) and screws (7).
NOTE
Use square hole in drive belt/tension pulley to
apply and maintain tension on drive belt while
adjusting belt tension.
(3) Adjust water pump drive belt with drive belt/tension
pulley (4) as follows:
(a) New belt (less than 30 minutes running time) 115-
125 lb (512-556 N).
(b) Used belt 80-100 lb (356-444 N).
(4) Tighten two screws (7) to 35 lb-ft (47 N m).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals