 |
|||
|
|
|||
|
Page Title:
AIR PRESSURE TEST STE/ICE-R TEST #50 |
|
||
| ||||||||||
|
|
 TM 9-2320-366-20-3
WARNING
Wear protective goggles to protect against
possible injury from release of high pressure
air. Failure to comply may result in injury to
personnel.
NOTE
Tag air hose and connection point prior to
disconnecting.
AIR PRESSURE TEST STE/ICE-R TEST #50
(1) Disconnect air hose from solenoid valve
listed in Table 2-66. Wrecker Function
Solenoid Valves and Actuators.
(2) Install test adapter on solenoid valve.
(3) Install STE/ICE-R 0-1000 psi transducer
on test adapter.
(4) Start engine (TM 9-2320-366-10-1).
(5) Position WRECKER REMOTE CONTROL
switch listed in Table 2-66. Wrecker
Function Solenoid Valve.
(6) Perform STE/ICE-R Test #50 and note
reading on STE/ICE-R.
(7) If 75 to 120 psi (517 to 827 kPa) is not
present, notify DS Maintenance.
(8) Shut down engine (TM 9-2320-366-10-1).
(9) Drain air tanks (TM 9-2320-366-10-1).
(10) Remove STE/ICE-R and test adapter from
solenoid valve.
(11) Install air hose on solenoid valve.
Wrecker Remote
Upper or Lower
Actuator and
Function
Control Switch
Valve Actuator
Solenoid Valve
Position
Air Hose Position
Underlift Fold Up
Up
L18
Lower Front
Underlift Fold Down
Down
L15
Lower Rear
Stinger In
In
L16
Lower Front
Stinger Out
Out
L13
Lower Rear
Underlift Up
Up
L14
Lower Front
Underlift Down
Down
L11
Lower Rear
Main Winch LH In
In
L6
Upper Front
Main Winch LH Out
Out
L5
Upper Rear
Main Winch RH In
In
L2
Lower Front
Main Winch RH Out
Out
L1
Lower Rear
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals