 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-3
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Remove dust boot from terminal lug TL23.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter to
terminal lug TL23.
(4) Connect negative (-) probe of multimeter to
a known good ground and note reading on
multimeter.
(5) If 24 VDC is not present, replace circuit
breaker CB11 (para 20-81).
(6) If 24 VDC is present, replace power cable
from terminal lug TL23 to terminal lug TL16
(para 20-81).
NOTE
Perform steps (7) through (9) if circuit
breaker CB11 is faulty.
(7) Position electrical distribution block cover
on power distribution shelf.
(8) Tighten wing screw on electrical
distribution block cover.
(9) Install wing screw on power distribution
shelf.
Change 2
2-2279
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals