RELAY TEST WIRE - TM-9-2320-366-20-21417

TM 9-2320-366-20-2

E-9. RELAY TEST WIRE

Fabricate the relay test wire according to the following steps. Refer to the following parts list for materials.

Material Description

National Stock

Cut Length

Number

Wire, Electrical (MIL-W-16878)

6145-00-330-3318

6 in. (152 mm)

a. Dimensions are in inches (millimeters).

b. Cut a length of wire six inches (152 mm) long.

c. Remove approximately 3/4 in. (19 mm) of electrical insulation from each end of wire.

E-10. TRANSMISSION AUXILIARY OIL COOLER RUBBER SEAL

Fabricate the transmission auxiliary oil cooler rubber seals in accordance with the following parts list.

Part Number

Description

National Stock

Cut Length

Number

inches

MIL-R-6130

Tape, Adhesive, Rubber

9320-00-501-7537

24.7

627

E-11. WHEEL BEARING SHIM TOOL REST

Fabricate the wheel bearing shim tool rest according to the following steps. Refer to the following parts list for

materials.

Part Number

National Stock Number

Description

QQ-T-570

9510-00-866-1037

Bar, Metal

a. Dimensions are in inches (millimeters)

b. Cut metal bar to 9.0 inches (228.6 mm) long.

c. De-burr and remove sharp edges from ends of metal bar.

E-12. PNEUMATIC TUBES FABRICATION

Cut pneumatic tubes from bulk tubing stock listed in Table E-1. Pneumatic Tube Lengths. Use a fine-toothed

hacksaw or suitable cutting device and cut tubing to required length.

Table E-1. Pneumatic Tube Lengths

Bulk Tubing

Cut Length

Tube Part

Part Number

inches

Number

12414690-001

NT-100-4 (79470)

18.1

46.0

12414690-002

NT-100-4 (79470)

16.0

40.6

12414690-003

NT-100-4 (79470)

15.0

38.1

12414690-004

NT-100-4 (79470)

74.8

190.0

12414690-005

NT-100-4 (79470)

69.7

177.0

E-17