 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
RESISTANCE TEST
(1) Disconnect connector P119 from
connector J119.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to connector P119. Refer to Table 2-36.
Connector P119 Transmission Solenoid
Resistance Test Points for appropriate sub
code(s) and connector P119 pin(s).
(4) Connect negative (-) probe of multimeter to
connector P119 and note reading on
multimeter. Refer to Table 2-36.
Connector P119 Transmission Solenoid
Resistance Test Points for appropriate sub
code(s) and connector P119 pin(s).
NOTE
Transmission solenoid resistance is
affected by temperature. Refer to Table
Resistance Readings.
(5) If resistance reading indicates transmission
solenoid is good, replace WTEC III
transmission ECU (para 8-7).
(6) If resistance reading indicates transmission
solenoid is faulty, notify DS Maintenance.
(7) Connect connector P119 to connector
J119.
(8) Position front grille on cab with washer
and screw.
(9) Position two washers and screws in front
grille.
(10) Tighten screw to 48-60 lb-in. (5-7 N∙m).
(11) Tighten two screws to 24 lb-in. (3 N∙m).
(12) Clear diagnostic codes (para 8-5).
Resistance Test Points
Temperature
Resistance
Connector P119
4 to 16F (-20 to -10C)
2.50-3.12
ohms
Sub
Code
16 to 32F (-10 to 0C)
2.62-3.25
ohms
Positive (+) Probe
Negative (-) Probe
32 to 50F (0 to 10C)
2.74-3.38
ohms
12
P119M
P119B
50 to 68F (10 to 20C)
2.86-3.50
ohms
13
P119T
P119N
68 to 86F (20 to 30C)
2.98-3.62
ohms
14
P119C
P119V
86 to 104F (30 to 40C)
3.09-3.75
ohms
15
P119W
P119B
104 to 122F (40 to 50C)
3.21-3.88
ohms
16
P119U
P119N
122 to 140F (50 to 60C)
3.33-4.00
ohms
21
P119F
P119H
22
P119D
P119V
23
P119P
P119S
24
P119J
P119B
26
P119K
P119A
27
P119M
P119B
Change 2
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals