 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Connect connector J116 to WTEC II VIM.
(2) Tighten screw in connector J116.
(3) Remove instrument panel assembly for
access (para 7-15).
(4) Disconnect connector J115 from WTEC II
TEPSS.
(5) Set multimeter ohms.
(6) Connect positive (+) probe of multimeter to
connector J115 socket 2.
(7) Connect negative (-) probe of multimeter to
connector J115 socket 11 and note reading
on multimeter.
(8) If continuity is not present, replace WTEC II
cab transmission harness (para 7-137).
(9) If continuity is present, replace WTEC II
TEPSS (para 8-2).
(10) Install kick panel (para 16-3).
(11) Connect batteries (para 7-57).
Change 1
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals