VOLTAGE TEST - TM-9-2320-366-20-20767

TM 9-2320-366-20-2

VOLTAGE TEST

(1)

Remove personnel heater to gain access

(para 18-9).

(2)

Disconnect connector P913 from connector

J913.

(3)

Set multimeter to ohms.

(4)

Connect positive (+) probe of multimeter to

connector J913-1.

(5)

Connect negative (-) probe of multimeter to

PDP, relay K12 socket 86 and note reading on

multimeter.

(6)

If continuity is not present, repair wire 1673

(para 2-45) or replace WTEC II dashboard cable

assembly (para 7-10) or WTEC III dashboard

cable assembly (para 7-11).

(7)

If continuity is present, repair wire 1673

(para 2-45) or replace auxiliary panel cable

assembly (para 7-58).

(8)

Connect connector P913 to connector J913.

(9)

Install relay K12 in PDP.

(10)

Install personnel heater (para 18-9).

(11)

Connect connector P906 to blackout override

switch.

(12)

Position auxiliary panel on auxiliary panel

housing with six screws.

(13)

Tighten six screws to 24 lb-in. (3 Nm).

2-1575