 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1)
Install circuit breaker CB 50 in PDP.
(2)
Install PDP cover on PDP (para 16-2).
(3)
Disconnect batteries (para 7-57).
(4)
Set multimeter to ohms.
(5)
Connect positive (+) probe of multimeter
to connector P911 socket 3.
(6) Connect negative (-) probe of multimeter
to connector P909 socket 5 and note
reading on multimeter.
(7) If continuity is not present, repair wire
2006 from connector P911 socket 3 to
connector P909 socket 5 (para 2-45) or
replace auxiliary panel cable assembly
(para 7-58).
(8) Connect connector P911 to DUMP BED UP/
DOWN switch.
Change 1
2-1490.5
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals