 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
CONTINUITY TEST
(1) Disconnect connector P172 from
connector J172.
(2) Set multimeter to ohms.
(3) Connect positive (+) probe of multimeter
to connector P172 socket F.
(4) Connect negative (-) probe of multimeter
to connector P108 socket 6 and note
reading on multimeter.
(5) If continuity is not present, repair wire
2043 from connector P172 socket F to
connector P108 socket 6 (para 2-45)
or replace M1090/M1094 dump power
cable assembly (para 7-125).
(6) If continuity is present, repair wire 2043
from connector J172 Pin F to connector
L8 socket 1 (para 2-45) or replace
M1090/M1094 dump cable assembly
(para 7-124).
(7) Connect connector P172 to connector
J172.
(8) Connect connector P108 to connector
J108.
(9) Install kick panel (para 16-3).
(10) Connect batteries (para 7-57).
(11) Lift dump body.
(12) Place maintenance legs in stowed
position.
(13) Lower dump body.
(14) Remove cargo sling from dump body
lifting brackets.
(15) Remove two dump body lifting brackets
from dump body.
(16) Position two locking pins in dump body.
(17) Install safety pin in two locking pins.
Change 1
2-1490.3
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals