 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Set multimeter to volts dc.
(2)
Connect positive (+) probe of multimeter to
terminal lug TL159.
(3)
Connect negative (-) probe of multimeter to
ground.
(4)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(5)
If 24 vdc is not present, repair wire 1463
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6)
Position master power switch to off
(TM 9-2320-366-10-1).
CONTINUITY TEST
(1)
Remove relay K19 from PDP.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter to
terminal lug TL158.
(4)
Connect negative (-) probe of multimeter to
PDP, terminal 86, where relay K19 was
removed, and note reading on multimeter.
(5)
If continuity is not present, repair wire 1637
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6)
Connect terminal lugs TL158 and TL159 to
start inhibit pushbutton switch.
2-1139
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals