 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-2
TM
WARNING
Remove rings, bracelets, watches,
necklaces, and any other jewelry
before working around vehicle.
Jewelry can catch on equipment
and cause injury or short across
electrical circuit and cause severe
burns or electrical shock.
VOLTAGE TEST
(1)
Set multimeter to volts dc.
(2)
Connect positive (+) probe of multimeter to
connector PX13-1.
(3)
Connect negative (-) probe of multimeter to
ground.
(4)
Position master power switch to on
(TM 9-2320-366-10-1) and note reading on
multimeter.
(5)
If 24 vdc is not present, repair wire 1401
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(6)
Position master power switch to off
(TM 9-2320-366-10-1).
CONTINUITY TEST
(1)
Disconnect connector P31 from connector
J31.
(2)
Set multimeter to ohms.
(3)
Connect positive (+) probe of multimeter to
connector PX13-3.
(4)
Connect negative (-) probe of multimeter to
connector J31-2 and note reading on
multimeter.
(5)
If continuity is not present, repair wire 1402
(para 2-45) or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
2-1115
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals