 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
NOTE
Remove plastic cable ties as required.
(1) Disconnect connector P52R from
connector J52.
(2) Set multimeter to volts dc.
(3) Connect positive (+) probe of multimeter
to connector P52R-3.
(4) Connect negative (-) probe of multimeter
to ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) If 12 vdc is not present, repair wire 489
(para 2-45) or replace rear lights cable
assembly (para 7-84 or 7-104).
(7) If 12 vdc is present, replace rear
intervehicular 12 vdc (7 pin) cable
(para 7-128).
(8) Position main light switch to OFF
(TM 9-2320-366-10-1).
NOTE
Install plastic cable ties as required.
(9) Connect connector P52R to connector J52.
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals