 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1)
Remove PDP cover (para 16-2).
(2)
Remove circuit breaker CB71 from PDP.
(3)
Remove relay K9 from PDP.
(4)
Set multimeter to volts DC.
(5)
Connect positive (+) probe of multimeter
to PDP, terminal 30, where relay K9 was
removed.
(6) Connect negative (-) probe of multimeter to
ground.
(7) Install circuit breaker CB71 in PDP and
and note reading on multimeter.
(8) If 12 VDC is not present, repair wire
1566 from relay K9 terminal 30 to circuit
breaker CB 71 (para 2-45) or replace
WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
VOLTAGE TEST
(1) Set multimeter to volts DC.
(2) Connect positive (+) probe of multimeter
to PDP, terminal 86, where relay K9 was
removed.
(3) Connect negative (-) probe of multimeter
to ground.
(4) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and not reading on
multimeter.
(5) If 12 VDC is not present, repair wire
1514 from relay K9 terminal 86 to circuit
breaker CB74 (para 2-45) or replace
WTEC II dashboard cable assembly
(para 7-10) or WTEC III dashboard cable
assembly (para 7-11).
(6) Position main light switch to OFF
(TM 9-2320-366-10-1).
All data on pages 2-718 and 2-719 deleted.
Change 1
2-717/(2-718 Blank)
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals