 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM
TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits
and cause severe burns or electrical shock.
VOLTAGE TEST
(1) Remove seven screws and washers from
kick panel.
(2) Remove kick panel and stiffener from
dashboard.
(3) Disconnect connector P65 from connector
J65.
(4) Set multimeter to volts dc.
(5) Connect positive (+) probe of multimeter
to connector P65-1.
(6) Connect negative (-) probe of multimeter to
ground.
(7) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1).
(8) Position warning light switch to on
(TM 9-2320-366-10-1).
(9) If 12 vdc is not present, repair wire 509
(para 2-45)or replace WTEC II dashboard
cable assembly (para 7-10) or WTEC III
dashboard cable assembly (para 7-11).
(10) If 12 vdc is present, repair wire 509
(para 2-45) or replace warning light cable
assembly (para 22-5).
(11) Position warning light switch to off
(TM 9-2320-366-10-1).
(12) Position main light switch to OFF
(TM 9-2320-366-10-1).
(13) Connect connector P65 to connector J65.
(14) Install kick panel (para 16-3).
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals