 |
|||
|
|
|||
|
|
|||
| ||||||||||
|
|
 TM 9-2320-366-20-1
WARNING
Remove rings, bracelets, watches, necklaces,
and any other jewelry before working around
vehicle. Jewelry can catch on equipment and
cause injury or short across electrical circuits,
or cause severe burns or electrical shock.
CAUTION
Use care when testing electrical connectors.
Do not damage connector pins or sockets
with multimeter probes. Failure to comply
may result in damage to equipment.
NOTE
Inspect connector pins/sockets for damage,
corrosion, and serviceability. Check that
connector pins are not pushed back and
are capable of making good contact.
VOLTAGE TEST
(1) Disconnect connector P78 from LH
composite taillight assembly.
(2) Set multimeter to volts DC.
(3) Connect positive (+) probe of multimeter to
connector P78.
(4) Connect negative (-) probe of multimeter to
ground.
(5) Position main light switch to SER DRIVE
(TM 9-2320-366-10-1) and note reading
on multimeter.
(6) If 12 VDC is not present, repair wire 21
(refer to Table 2-12.17. Composite
Taillight Connectors) (para 2-45) or
replace M1083/M1084/M1085/M1090/
M1092/M1093/M1094/M1096 rear lights
cable assembly (para 7-84) or M1086/
M1088/M1089 rear lights cable assembly
(para 7-104).
(7) Position main light switch to OFF
(TM 9-2320-366-10-1).
Model
Splice
M1083/M1084/M1085/M1086/
Connector P78 to Splice E20
M1090/M1093/M1094/M1096
M1088
Connector P78 to Splice E32
M1089
Connector P78 to Splice E48
Change 1
2-612.11
|
|
Privacy Statement - Press Release - Copyright Information. - Contact Us |
Click
here for thousands of PDF manuals