CONTINUITY TEST - TM-9-2320-366-20-11075

TM 9-2320-366-20-1

CONTINUITY TEST

(1) Remove nut, lockwasher, terminal lug TL20,

and lockwasher from RH rear marker light

screw. Discard lockwashers.

(2) Step multimeter to ohms.

(3) Connect positive (+) probe of multimeter

to terminal lug TL20.

(4) Connect negative probe of multimeter to

ground and note reading on multimeter.

(5) If continuity is not present, repair wire 3095

from terminal lug TL20 to terminal lug TL21

(para 2-45) and go to step 9 of this fault if

required or replace M1086/M1089 rear

lights cable assembly (para 7-104) or

M1085/M1096 rear lights cable assembly

(para 7-84) and go to step 1 of this fault.

(6) If continuity is present, repair wire 489 from

splice "A" to splice "B" (refer to Table

2-12.14. M1085/M1086/M1089/M1096

RH Rear Marker Light Splices) (para 2-45)

and go to step 9 of this fault if required or

replace M1086/M1089 rear lights cable

assembly (para 7-104) or M1085/ M1096

rear lights cable assembly (para 7-84) and

go to step 1 of this fault.

(7) Install lockwasher, terminal lug TL20,

lockwasher, and nut on RH rear marker light

screw.

Table 2-12.14. M1085/M1086/M1089/M1096

RH Rear Marker Light Splices

Model

Splice "A"

Splice "B"

M1085/M1086/M1096

E15

E17

M1089

E49

E52

Change 1

2-604.143